Myelopathy Cervical
Conditions
Brief summary
This study aims to evaluate gait impairment in patients with Degenerative Cervical Myelopathy (DCM) before and after surgery using an inertial measurement unit (IMU) sensor. By comparing IMU-derived gait parameters with traditional clinical assessment tools (e.g., Modified Ashworth Scale, mJOA, and GRASSP), the study seeks to determine the effectiveness and reliability of IMU sensors for assessing and monitoring gait improvement and neurological recovery in DCM patients. This study is conducted outside the United States and does not involve interventions or devices subject to U.S. FDA regulation.
Detailed description
This observational study will investigate the correlation between gait parameters measured with an IMU sensor and established clinical evaluation tools for patients with Degenerative Cervical Myelopathy (DCM). The primary aim is to quantify gait impairments before and after surgical intervention and to verify the IMU sensor's utility as a quantitative assessment tool. The study will recruit both DCM patients and a control group to evaluate the sensitivity of the IMU sensor in detecting fine motor and gait differences. Outcomes will be analyzed using statistical comparisons of pre- and post-surgery measurements, with specific focus on gait speed, cadence, stride length, and spasticity. The anticipated goal is to validate the IMU sensor as a reliable alternative to existing clinical tools, facilitating early detection of gait impairment and monitoring post-surgical improvement in DCM patients. This study is conducted entirely outside the United States and does not involve interventions or devices subject to U.S. FDA regulation. The devices and procedures used in this study are approved by local regulatory authorities in the country where the study is conducted. The study complies with applicable international and local guidelines rather than U.S. FDA requirements.
Interventions
DEVICEGait Analysis Using IMU Sensor
Inertial Measurement Unit (IMU) sensor-based 3D gait analysis to assess spasticity and gait impairment. This intervention aims to provide quantitative data on gait parameters in DCM patients before and after surgery.
Sponsors
Pusan National University Yangsan Hospital
Study design
Observational model
OTHER
Time perspective
OTHER
Eligibility
Sex/Gender
ALL
Age
18 Years to No maximum
Healthy volunteers
No
Inclusion criteria
* Age 18 years or older. * Able to communicate and provide informed consent. * Capable of walking at least 3 meters without assistance from others or walking aids. * No prior surgical treatment for cervical myelopathy. * Lower limb motor function score of 2 or higher on the mJOA scale.
Exclusion criteria
* Presence of severe respiratory or cardiac conditions that impede safe walking. * Musculoskeletal issues, such as spinal deformities, affecting gait. * History of neurological disorders affecting gait, including peripheral nerve injury, joint stiffness, stroke, traumatic brain injury, myelitis, or Parkinson's disease. * Prior orthopedic or neurosurgical interventions that could impact gait. * Cervical conditions resulting from trauma (acute fracture or acute disc herniation), tumor, or infection.
Design outcomes
Primary
| Measure | Time frame | Description |
|---|---|---|
| Step Length | 10 days before surgery, 10 days after surgery, and 30 days after surgery. | Step length is measured in centimeters (cm) to independently evaluate the gait characteristics of patients with Degenerative Cervical Myelopathy (DCM). Step length is defined as the distance covered between two successive placements of the same foot and is a critical parameter to assess balance and mobility. |
| Walking Speed | 10 days before surgery, 10 days after surgery, and 30 days after surgery. | Walking speed is measured in kilometers per hour (km/h) to independently assess the gait characteristics of patients with Degenerative Cervical Myelopathy (DCM). Walking speed evaluates the efficiency of ambulation over a defined distance and is a vital measure of functional mobility. |
| Stride Length | 10 days before surgery, 10 days after surgery, and 30 days after surgery. | Stride length is measured in centimeters (cm) to independently evaluate the gait characteristics of patients with Degenerative Cervical Myelopathy (DCM). Stride length is defined as the distance covered in one complete gait cycle and provides insights into the patient's walking stability. |
| Cadence | 10 days before surgery, 10 days after surgery, and 30 days after surgery. | Cadence is measured in steps per minute (steps/min) to independently assess the gait characteristics of patients with Degenerative Cervical Myelopathy (DCM). Cadence represents the number of steps taken per minute and is used to analyze walking rhythm and patterns. |
Secondary
| Measure | Time frame | Description |
|---|---|---|
| Modified Japanese Orthopaedic Association (mJOA) Score | 10 days before surgery, 10 days after surgery, and 30 days after surgery. | The mJOA score is used to assess neurological function in patients with Degenerative Cervical Myelopathy (DCM). This score evaluates motor dysfunction, sensory dysfunction, and bladder function. The score ranges from 0 (worst outcome) to 18 (best outcome), with higher scores indicating better neurological function. |
| Modified Ashworth Scale (MAS) | 10 days before surgery, 10 days after surgery, and 30 days after surgery. | The MAS score is used to assess spasticity in patients with Degenerative Cervical Myelopathy (DCM). The scale ranges from 0 (no increase in muscle tone) to 4 (rigid in flexion or extension). Lower scores indicate better outcomes, reflecting reduced spasticity. |
Contacts
Primary ContactSungchul Huh, PhD
Backup ContactSungchul Huh, PhD
Outcome results
None listed